HP Slate 10 HD 3500ca HP Slate10 HD and HP Slate7 HD Maintenance and Service G - Page 37
that secure the USB board to the, Remove the two Phillips PM2.0×2.0 broad head screws
View all HP Slate 10 HD 3500ca manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Remove the USB board: 1. Remove the rubber pad (1) that protects the USB board cable ZIF connector. 2. Release the ZIF connector (2) to which the USB board cable is attached, and then disconnect the USB board cable from the system board. 3. Detach the USB board cable (3) from the display panel assembly. (The USB board cable is attached to the display panel assembly with double-sided adhesive.) 4. Remove the two Phillips PM2.0×2.0 broad head screws (4) that secure the USB board to the display panel assembly. 5. Remove the USB board bracket (5) and the USB board (6). Reverse this procedure to install the USB board. HP Slate10 HD 31
Remove the USB board:
1.
Remove the rubber pad
(1)
that protects the USB board cable ZIF connector.
2.
Release the ZIF connector
(2)
to which the USB board cable is attached, and then disconnect the
USB board cable from the system board.
3.
Detach the USB board cable
(3)
from the display panel assembly. (The USB board cable is
attached to the display panel assembly with double-sided adhesive.)
4.
Remove the two Phillips PM2.0×2.0 broad head screws
(4)
that secure the USB board to the
display panel assembly.
5.
Remove the USB board bracket
(5)
and the USB board
(6)
.
Reverse this procedure to install the USB board.
HP Slate10 HD
31