HP Slate 21 Pro PC User Guide - Page 13
Setting up the hardware, Preparing for desk use, Preparing for wall mounting
![]() |
View all HP Slate 21 Pro PC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
2 Setting up the hardware You can install the all-in-one on a desktop or mount it to a mounting fixture such as a wall mount or swing arm. Be sure to place the all-in-one in a convenient, well-ventilated location. Connect the cables after you have installed the all-in-one to a mounting fixture. To set up the all-in-one, ensure that the power is turned off to the all-in-one and all attached accessories, and then follow the instructions below for your configuration. Preparing for desk use To assemble the all-in-one for desktop use: 1. Set the all-in-one face down on a table or desk covered by a clean, dry cloth. 2. Pull the stand outward. 3. Lift the all-in-one to an upright position and place on a flat, stable surface. Preparing for wall mounting NOTE: This all-in-one is intended to be supported by UL or CSA Listed wall mount bracket. To attach the all-in-one to a mounting fixture: 1. Set the all-in-one face down on a flat, soft, protected table or desk surface. Preparing for desk use 5
![](/manual_guide/products/hewlettpackard-slate-21-pro-pc-user-guide-21afe94/13.png)