HP StorageWorks 8/40 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 434
SEC-1083, Recommended, Action, Severity, Message, Probable Cause, secFabricShow
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 434 highlights
66 SEC-1083 Recommended Use proper syntax when creating policies. If the security database is too large, you must delete Action other members within the database before adding new members to a policy. Severity ERROR SEC-1083 Message , [SEC-1083], ,, ERROR, , Name already exists. Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configurations server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR SEC-1084 Message , [SEC-1084], ,, ERROR, , Name exists for different type . Probable Cause Indicates that the specified policy already exists. Recommended No action is required. Action Severity ERROR SEC-1085 Message , [SEC-1085], ,, ERROR, , Failed to create . Probable Cause Indicates that the security policy was not created. Recommended Check that the current policy configuration is valid. For example, the RSNMP policy cannot exist Action without the WSNMP policy. Severity ERROR SEC-1086 Message , [SEC-1086], ,, ERROR, , The security database is too large to fit in flash. 382 Fabric OS Message Reference 53-1000600-02