HP StorageWorks 8/40 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 93
AUTH-1037, Indicates that the public key infrastructure PKI certificate is not installed properly.
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
AUTH-1037 3 If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1037 Message , [AUTH-1037], ,, ERROR, , Failed to response for : init_len , resp_len , port . Probable Cause Indicates that a Diffie Hellman - challenge handshake authentication protocol (DH-CHAP) authentication operation failed on the specified port due to mismatched response values between two entities. Recommended Action The error might indicate that an invalid entity tried to connect to the switch. Check the connection port for a possible security attack. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1038 Message , [AUTH-1038], ,, ERROR, , Failed to retrieve certificate during : port . Probable Cause Indicates that the public key infrastructure (PKI) certificate is not installed properly. Recommended Action Reinstall the PKI certificate, using the pkiCreate command. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1039 Message Probable Cause , [AUTH-1039], ,, ERROR, , Neighboring switch has conflicting authentication policy: Port disabled. Indicates that the neighboring switch has a conflicting authentication policy enabled. The_E-Port has been disabled, because the neighboring switch rejected the authentication negotiation, and the local switch has a strict switch authentication policy. Fabric OS Message Reference 41 53-1000600-02