HP StorageWorks 8/40 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 58
Viewing System Messages from Web Tools, Dumping System Messages
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
1 Viewing and Configuring System Message Logs TABLE 2 Commands for Viewing or Configuring the System Parameters and Logs (Continued) Command Description supportFfdc Enables and disables FFDC (first failure data capture). supportSave Collects RASLog, trace files, and supportShow (active CP only) information for the local CP and then transfers the files to an FTP server. The operation can take several minutes. supportShow Executes a list of diagnostic and error display commands. This output is used by your switch service provider to diagnose and correct problems with the switch. The output from this command is very long. syslogDIpAdd Adds an IP address as a recipient of system messages. syslogDIpRemove Removes an IP address as a recipient of system messages. syslogDIpShow Views the currently configured IP addresses that are recipients of system messages. syslogdFacility Changes the syslogd facility. systemVerification Use this command to run a comprehensive system wide test of all switches in a system. It will initiate a burnin run on all switches within the current system. Note that any reference seen to slot 0 is a reference to the blade within the switch platform, e.g.,Brocade 7500 and AP7600 contain FR4-18i and FA4-18 blades respectively. traceDump Displays, initiates, or removes a Fabric OS module trace dump. traceTrig Sets, removes, or displays trace triggers. Viewing System Messages from Web Tools To view the system message log for a switch from Web Tools: 1. Launch Web Tools. 2. Select the desired switch from the Fabric Tree. The Switch View displays. 3. Click the Switch Events button. A Switch Events Report displays. 4. View the switch events and messages. In dual-domain switches, an Event button exists for each logical switch. Only messages relating to that switch (and chassis) will be displayed. Dumping System Messages To display the system message log, with no page breaks: 1. Log in to the switch as admin. 2. Enter the errDump command at the command line: switch:admin> errDump Version: 5.0.1 2004/07/28-17:04:59, [FSSM-1002], 1,, INFO, switch, HA State is in sync 2004/07/28-17:04:59, [FSSM-1003], 2,, WARNING, switch, HA State out of sync 6 Fabric OS Message Reference 53-1000600-02