HP StoreOnce D2D4324 HP D2D25xx, 41xx and 43xx Backup System user guide (EH985 - Page 71
Add Target Appliance, Create New Target, Share, Replication Source, Permissions
![]() |
View all HP StoreOnce D2D4324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
7. Select a Target Appliance from the list and click Next. NOTE: If you want to select an appliance that is not yet on the list, click Add Target Appliance. Enter the Target Appliance IP Address or fully qualified domain name. The default values for the Command and Data Protocol Port Numbers are usually acceptable, but may be edited if there is a conflict. (If replication needs to take place through a firewall, the network administrator will need to open (TCP) ports 9387 (Command protocol) and 9388 (Data protocol) to allow the replication traffic to pass to and from the HP StoreOnce Backup Systems.) Click Add Target Appliance. 8. The wizard then moves to the Select Target Share step. Select a share on the target appliance and click Next. NOTE: If you need to create a new share on the target appliance, click Create New Target Share. Set up the details as you would normally do when creating a new share. You cannot create a new target share if the appliance to be used as the target has Replication Source Permissions enabled. 9. Give the Share Mapping a name and click Next. NAS Mappings (Replication) 71
![](/manual_guide/products/hewlettpackard-d2d2502i-hp-d2d25xx-41xx-43xx-backup-user-guide-eh98590955-2013-dfad14b/71.png)