HP Stream 11-y000 Maintenance and Service Guide - Page 35

Before replacing the computer feet, follow these steps, Carefully remove the rubber feet

Get HP Stream 11-y000 PDF manuals and user guides View all HP Stream 11-y000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

Before replacing the computer feet, follow these steps: ▲ Prepare the computer for disassembly (Preparation for disassembly on page 26). Remove the computer feet: NOTE: The appearance of the rubber feet and the number of screws may differ for your computer. 1. Close the computer and position it upside down, with the front toward you. 2. Insert a tool (1) with no sharp edges between the base enclosure and one end of the rubber feet. 3. Pull up the rubber feet (2) lightly and quickly. 4. Carefully remove the rubber feet (3). To install the rubber feet, refit them on the adhesive backing. NOTE: The bottoms of the computer feet are ribbed. These ribs are designed to fit only one way in the grooves that are in the enclosure. Make sure the feet are positioned in those grooves when reinstalling the feet. Component replacement procedures 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
Before replacing the computer feet, follow these steps:
▲
Prepare the computer for disassembly (
Preparation for disassembly
on page
26
).
Remove the computer feet:
NOTE:
The appearance of the rubber feet and the number of screws may
differ
for your computer.
1.
Close the computer and position it upside down, with the front toward you.
2.
Insert a tool
(1)
with no sharp edges between the base enclosure and one end of the rubber feet.
3.
Pull up the rubber feet
(2)
lightly and quickly.
4.
Carefully remove the rubber feet
(3)
.
To install the rubber feet,
refit
them on the adhesive backing.
NOTE:
The bottoms of the computer feet are ribbed. These ribs are designed to
fit
only one way in the
grooves that are in the enclosure. Make sure the feet are positioned in those grooves when reinstalling the
feet.
Component replacement procedures
27