HP Stream 11-y000 Maintenance and Service Guide - Page 49

Remove the system board, by sliding it up and to the left at an angle.

Get HP Stream 11-y000 PDF manuals and user guides View all HP Stream 11-y000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

3. Release the ZIF connector (3) to which the connector board cable is attached, and then disconnect the connector board cable from the system board. 4. Remove the four Phillips M2.0 × 3.3 screws (1) that secure the system board to the bottom cover. 5. Release the system board by lifting the left side of the system board (2) until it rests at an angle. 6. Remove the system board (3) by sliding it up and to the left at an angle. Reverse this procedure to install the system board. Component replacement procedures 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
3.
Release the ZIF connector
(3)
to which the connector board cable is attached, and then disconnect
the connector board cable from the system board.
4.
Remove the four Phillips M2.0 × 3.3 screws
(1)
that secure the system board to the bottom cover.
5.
Release the system board by lifting the left side of the system board
(2)
until it rests at an angle.
6.
Remove the system board
(3)
by sliding it up and to the left at an angle.
Reverse this procedure to install the system board.
Component replacement procedures
41