HP Surestore E Tape Library Model 2/20 HP SureStore E Tape Library Models 2/20 - Page 235
Using HP Ultrium Cartridges
View all HP Surestore E Tape Library Model 2/20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 235 highlights
CAUTION CAUTION Drives and Media HP Ultrium Drives & Media Using HP Ultrium Cartridges HP Ultrium tape drives require special cleaning cartridges and data cartridges formatted specifically for HP Ultrium. To avoid damage to your tape drive, it is critical to use appropriate cleaning cartridges and properly formatted data cartridges. A unique feature of Ultrium tape cartridges is LTO-Cartridge Memory (LTO-CM). LTO-CM is an intelligent memory chip embedded into the cartridge. It uses a radio frequency interface that eliminates the need for a physical power or signal connection between the cartridge and drive. Information normally stored in the header at the beginning of the tape is contained in the LTO-CM, including identification and usage information such as the number of times the cartridge has been loaded, when it was last cleaned, and error logs. See the following sections for information on: • Inspecting DLT Cartridges • Write-Protecting DLT Cartridges • Using DLT Cartridge Bar Code Labels • Loading DLT Cartridges into a Magazine • Using DLT Cleaning Cartridges In addition to the information provided in this manual, you may also want to refer to the documentation provided with your Ultrium media. Maintaining Ultrium Cartridges Make it a practice to visually inspect your tape cartridges when loading or removing them from your tape library. Taking a few minutes to check the condition of your cartridges will lower the risk of repeated failures and help ensure uninterrupted backup. Do not apply more than one label onto Ultrium cartridges, as extra labels can cause the cartridges to jam in the tape drive. Do not bulk erase Ultrium formatted cartridges. This will destroy prerecorded servo information and make the cartridges unusable. Drives & Media Appendix D D-21