HP Surestore E Tape Library Model 2/20 HP SureStore E Tape Library Models 2/20 - Page 70

NOTE NOTE WARNING Library Installation Moving or Shipping the Library You do not need to remove the SCSI cables that connect the controller or the Fibre Channel interface to the drive modules, unless the library is being shipped. 7. To move a stand-alone library, move it to its new location and reconnect it using the procedures in "Connecting and Powering on the Library" on page 1-24. • For shipping, place the library in the original packing materials. If you no longer have the original packaging, contact your service representative to obtain packaging materials, or order direct from Hewlett-Packard. The part numbers are listed in Table 1-5 on page 1-56. • For libraries mounted in a rack, proceed to the next step. 8. Extend the rack's anti-tip foot. Failure to extend the anti-tip foot could result in personal injury or damage to the library. 9. Open the magazine doors and loosen the screws that lock the library into place (Figure 1-14 on page 1-22). The screws are located in front of the trim brackets. 10. Remove the stop bracket. (See Figure 1-9 on page 1-18 and Figure 1-10 on page 1-19.) 11. Push the library out of the rack until it hits the latch stops (approximately 2/3 of the library is out of the rack). 12. Reattach the lifting straps to the sides of the library. 13. Release the library from the rack. • 40-Slot and 60-Slot Libraries: Depress the latch stops at the top of the library with a screwdriver or similar tool (Figure 1-26 on page 1-55). 1-54 Chapter 1