HP Surestore E Tape Library Model 2/20 HP SureStore E Tape Library Models 2/20 - Page 39
Preparing the Host for Installation
View all HP Surestore E Tape Library Model 2/20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
NOTE Library Installation Preparing the Host for Installation Preparing the Host for Installation Ensure that you have a host bus adapter card that is compatible with the library. Install the SCSI host bus adapter card(s) and compatible driver(s). Refer to the host computer user manual and host bus adapter card instructions, and follow these general steps: 1. When the host is powered on, install software and/or driver(s) into the host that are compatible with the library. 2. If the host computer is connected to a network, check with the system administrator before turning off power. 3. Properly power off all peripheral devices connected to the host computer. 4. Power of the host. • Use proper procedures to prevent electrostatic discharge (ESD). Use wrist-grounding straps and anti-static mats when removing internal components. • Make sure that the host computer has an appropriate number of card expansion slots available for your library model. • Ensure the host bus adapter card is supported by your backup software application. • For optimum performance, there should be a maximum of one tape drive per bus. HP supports up to two drives per SCSI host bus adapter but recommends only one drive per bus. If compression is used when attaching two drives per bus, keep in mind the combined transfer rate of the drives must not exceed the throughput of the host bus adapter used. • Refer to Appendix A and the ANSI SCSI cable specification for more information on SCSI cable length requirements. • Check for available SCSI IDs if you are installing the library onto the same SCSI bus as other devices. You might need to change the SCSI ID from the library front panel if you think there will be an ID conflict with other devices. Chapter 1 1-23 Getting Started