HP Tc2120 HP Server Ultra 3 SCSI Host Bus Adapter Installation and Configurati - Page 52
adpt160m.ham Command Line Options, Table 5-1., Option, Values, Default, Description
UPC - 808736945332
View all HP Tc2120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Chapter 5 Novell NetWare Installation adpt160m.ham Command Line Options Table 5-1. adpt160m.ham Command Line Options Option auto_disable_tagq= dev_enable= flush_diskreq= instr= lun_enable=1 max_tags= Values on, off Default off 0-FFFF FFFF 0-FFFF 0 on, off off 0-FF 01 1-128 16 Description Enables/disables auto disable tagged queuing algorithm. Allows you to enable the driver's registration of SCSI devices on a per target basis. By default, all targets are scanned. A bit value of 0 causes the target not to register under the operating system. These devices are still accessible via ASPI. This enable bit mask is entered in hex (see "Bit Mask Options" on page 47). A bit mask to send occasionally ordered tags to specific targets. By default, no targets receive occasionally ordered tags. This bit mask is entered in hex (see "Bit Mask Options" on page 47). Enables/disables recording of I/ O statistics. A bit mask to enable scanning for specific LUNs on all targets. The default value of 01 causes the driver to scan LUN 0 only. This enable bit mask is entered in hex (see "Bit Mask Options" on page 47.) Specifies maximum number of tagged commands per device. 46