HP Workstation x4000 hp workstation x4000 - Getting Started Guide - Windows (A - Page 14

Load the Software Applications for Your CD-RW, Connect the Power Cords

Get HP Workstation x4000 PDF manuals and user guides View all HP Workstation x4000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Setting Up And Using Your Workstation Setting Up Your Workstation Load the Software Applications for Your CD-RW The CD-RW software for the CD-RW drive that is installed in your HP x4000 Workstation is not included in the pre-loaded software. You must install the applications manually from the Applications CD-ROM (provided with the workstation or as an accessory kit) before you can use the write/re-write functionality of the drive. If you do not install these software packages, you can only use the CD-RW drive's read functionality. Connect the Power Cords WARNING For your safety, always connect equipment to a grounded wall outlet. Always use a power cord with a properly grounded plug, such as the one provided with the equipment, or one in compliance with your national safety standards. You disconnect the workstation from the power by removing the power cord from the power outlet. This means the equipment must be located close to an easily accessible power outlet. 1. Connect the power cords to the rear of the monitor and the workstation. 2. Connect the both power cords to a grounded outlet. 14 Chapter 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
Setting Up And Using Your Workstation
Setting Up Your Workstation
Chapter 1
14
Load the Software Applications for Your CD-RW
The CD-RW software for the CD-RW drive that is installed in your HP
x4000 Workstation is
not included in the pre-loaded software. You must
install the applications manually from the Applications CD-ROM
(provided with the workstation or as an accessory kit) before you can use
the write/re-write functionality of the drive.
If you do not install these software packages, you can only use the
CD-RW drive’s
read functionality.
Connect the Power Cords
WARNING
For your safety, always connect equipment to a grounded wall
outlet. Always use a power cord with a properly grounded plug,
such as the one provided with the equipment, or one in
compliance with your national safety standards. You disconnect
the workstation from the power by removing the power cord
from the power outlet. This means the equipment must be
located close to an easily accessible power outlet.
1. Connect the power cords to the rear of the monitor and the
workstation.
2. Connect the both power cords to a grounded outlet.