HP Xw6200 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 136

Adaptec SCSI RAID Software Reference Guide container remove file_system To remove the file system from an array, use the container remove file_system command. Use this command when the file system on the array is no longer needed. This command fails if there are open files on the array. Command Availability This command and its associated switches (if any) are supported on the following operating systems: ■ Windows NT ■ Windows 2000 (basic disk only) ■ Windows XP (basic disk only) Syntax container remove file_system {container} Parameters {container} Specifies the ID number (0 to 63) of the array from which you want to remove the file system. Examples Before removing a file system from an array, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a volume set) on this controller: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size F: 0 Volume 10.0MB NTFS 0:02:0 64.0KB: 10.0MB 5-88