HP Xw6200 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 83

container Commands container create volume To create a volume set from freespace, use the container create volume command. Notes If you created a volume set you can run the list devices command on the NetWare console to verify its creation and then create the necessary NetWare disk partitions and volumes. For information on how to create partitions and volumes, see the appropriate NetWare documentation. Syntax container create volume [/cache{=boolean}] [/ label{=string}] {scsi_device},{free_space} [{scsi_device},{free_space}...] Parameters {scsi_device} Specifies the ID for the SCSI device whose freespace you want to use for creating the volume set. A SCSI ID consists of a SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0 through 15 inclusive), and SCSI device logical unit number (0 through 7 inclusive). See the installation guide for your controller to determine the number of buses it actually supports. See the scsi_device section on page 3-7 for more information on how to specify the SCSI device. Note that you must explicitly specify the entire ID for the SCSI device (the SCSI channel number, device ID, and device logical unit number). {free_space} Specifies the freespace used to create the volume set on the specified SCSI device. See the free_space section on page 3-8 for more information on how to specify the freespace. 5-35