HP Xw6200 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 305
enclosure show temperature, If you do not specify a unit number, the command displays
UPC - 882780333536
View all HP Xw6200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 305 highlights
enclosure Commands enclosure show temperature To display the temperature status of a specific temperature sensor on a specific SAF-TE enclosure management device, use the enclosure show temperature command. You can also use this command to display the temperature status of all temperature sensors on the enclosure management device or devices. Syntax enclosure show temperature [{enclosure}] [{sensor}] Parameters {enclosure} Specifies the ID associated with the enclosure management device for which you want to display temperature status information. For this version, the controller supports a maximum of eight enclosure management devices on each bus. If you do not specify an ID, the command displays the temperature status information for all enclosure management devices connected to the controller. {sensor} Specifies the unit number associated with the temperature sensor whose status you want to display. This integer can range from 0 to 15 inclusive. If you do not specify a unit number, the command displays the status for all temperature sensors on the enclosure management device or devices. Examples The following example displays the temperature status of temperature sensor unit 0 on enclosure management device 0: AAC0>enclosure show temperature 0 0 Executing: enclosure show temperature 0 0 Enclosure Sensor Temperature Threshold Status 0 0 70 120 NORMAL 11-41