IBM 17231RX Installation Guide - Page 56
Removing, replacing, outer, slide, rails
UPC - 000435862730
View all IBM 17231RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Removing and replacing the outer slide rails To remove and replace the outer slide rails, complete the following steps: 1. Remove the eight screws that attach the outer slide rails to the rack cabinet, and then remove the old outer slide rails from the cabinet. 2. If you are installing the console unit in an IBM rack cabinet, no adjustment is necessary. Otherwise, loosen the two rail-adjustment screws on each of the outer slide rails and extend the rails to their maximum outward adjustment. Rail-adjustment screws 3. Adjust the outer slide-rail brackets to fit the depth of the rack cabinet, and then attach the front of the slide-rail brackets to the rack cabinet, using four screws. Make sure that the slide-rail brackets extend outside of the rack-cabinet mounting flanges. Note: Do not install screws in the middle holes in the slide-rail bracket. These holes are for the thumbscrews on the front of the console unit. 46 1U 17-inch Flat Panel Console Kit: Installation and Maintenance Guide