IBM 847661U Hardware Maintenance Manual - Page 131
and install another drive in that bay, use the screws, Therefore, if you remove a drive from bay
View all IBM 847661U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
4. If you are installing a drive in bay 5, turn the drive upside down before you slide it into the bay. This ensures that the drive connector will align with and attach properly to the cable connector. When you install the four screws that come with the drive, attach them to the drive from the top. The following illustration shows a drive being installed in bay 5. 5. If you are installing a drive in bay 6, turn the drive upside down before you slide it into the bay. This ensures that the drive connector will align with and attach properly to the cable connector. If the server comes with a drive installed in bay 6, two screws are attached to each side of the drive assembly. Therefore, if you remove a drive from bay 6 and install another drive in that bay, use the screws that come with the preinstalled drive. Note When using the rubber grommets (washers) to attach the drive to the rear drive cage, you must use the screws provided in the tray in bay 2. IBM Netfinity 3000 - Type 8476 123