IBM 847661U Hardware Maintenance Manual - Page 89
Controls and indicators, Server controls
![]() |
View all IBM 847661U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Socket 7 Controls and indicators The most commonly used controls and status indicators are on the front of the server. Server controls Power Switch CD-ROM Eject/Load Button Diskette Eject Button Power Switch: Press this switch to turn the server on or off. Attention Do not turn off the server if a drive in-use light is on. This might damage the information stored on a hard disk or on a diskette. When the power is on, there is a period of time during the power-on self-test (POST), a short test that occurs when the server is turned on, when a single touch of the power switch will not turn off the power. If power must be turned off during POST, press and hold the power switch for 5 seconds or disconnect the power cord. After POST, the power switch works normally, unless the server is in a hang condition. If the server is in a hang condition, press and hold the power switch until the power turns off. CD-ROM Eject/Load Button: Push this button to release a CD from the CD-ROM drive. See "CD-ROM drive" on page 74 for additional information about the CD-ROM drive controls and indicators. Diskette Eject Button: Push this button to release a diskette from the diskette drive. IBM Netfinity 3000 - Type 8476 81
![](/manual_guide/products/ibm-847620u-hardware-maintenance-manual-4ef1215/89.png)