IBM 847661U Hardware Maintenance Manual - Page 155
Diskette write-protect switch setting, The following illustration is for reference only.
View all IBM 847661U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Diskette write-protect switch setting: The diskette write-protect switch controls whether you can write information to a diskette using a diskette drive. The ability to prevent writing to a diskette is particularly useful if you are concerned about the security of information that can be obtained through a network. Note This switch does not affect the ability to read information from a diskette. Notes Read "Safety information" on page 212. Power-off the server and all other connected devices. Disconnect all external cables attached to the server; then, remove the server cover. 1. Locate the configuration switches (also known as rocker switches) on the system board. For more information, refer to the label inside the server, or see "System board illustration" on page 142. 2. For normal diskette operation or for read-only diskette operation, set switch 8 as shown in the following illustration. It might be helpful to use the end of a small screwdriver to set the switch. Attention: The following illustration is for reference only. Before you change the settings for switch 8, be sure that you check the orientation of the server system board to correctly identify the switch number locations. If you change the settings for the wrong switches, you might seriously damage server components or options. Normal Diskette Operation 12345678 ON OFF Read-Only Diskette Operation 12345678 ON OFF 3. After changing configuration switch settings, you must reconfigure the server. After reassembling the server (see "Completing the installation" on page 77), use the Configuration/Setup Utility program to reset the date and time, reset any passwords, and reconfigure the server. For more information, see "Configuration/Setup utility program menus" on page 24. IBM Netfinity 3000 - Type 8476 147