IBM 847671U Hardware Maintenance Manual - Page 140
See System board, Notes, To install a microprocessor
UPC - 087944520719
View all IBM 847671U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Notes 1. The microprocessor in the server comes with an attached heat sink. The microprocessor plugs into the microprocessor socket on the system board and is stabilized with a plastic bracket attached to the system board. This bracket is referred to as a goalpost. The type of heat sink in the server might be different from the heat sink shown in this section. 2. To locate the microprocessor switch area of the system board, find the rocker switches section of the system board illustration. See "System board illustration" on page 142. For information about the appropriate switch settings, see "Microprocessor speed switches settings" on page 153, or see the label inside the server. To install a microprocessor: 1. Remove the server side cover (see "Disconnecting cables and removing the side cover" on page 84). 2. Remove the microprocessor: a. Locate the microprocessor socket on the system board. (See the illustration in "System board illustration" on page 142.) b. Place your index fingers on the small retainer tabs on the top of the microprocessor. Push in toward the microprocessor until the tabs release. Tabs 132 Netfinity Server HMM