IBM 847671U Hardware Maintenance Manual - Page 143
Flash Utility Diskette, Flash Utility, Diskette, procedure see Remote administration
UPC - 087944520719
View all IBM 847671U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
6. Pull outward on the retainer tabs. 7. If you replace the microprocessor with one that has a different speed, you might have to change the switch settings on the system board. To locate the switches, see "System board illustration" on page 142. For information about the appropriate switch settings, see "Microprocessor speed switches settings" on page 153, or see the label inside the server side cover. 8. If you receive the error code 167 after you install a new microprocessor, run the Flash Utility program. Insert the Flash Utility Diskette into the primary diskette drive and run the flash program. Follow the instructions in the program. Note If you have not already done so, go to http://www.ibm.com/support/ on the World Wide Web and download the appropriate flash update program. Review the applicable README files, and use this information to create a Flash Utility Diskette. Perform the POST/BIOS (flash) update procedure (see "Remote administration" on page 34 for additional information). 9. Because you installed a new microprocessor in the server, you must reconfigure the server. Follow the procedure described in "Configuration/Setup utility program menus" on page 24. Refer to the operating-system documentation. You might need to make changes so that the operating system recognizes the new microprocessor. 10. If you want to install or remove any other options, do so now. Otherwise, go to "Completing the installation" on page 77. IBM Netfinity 3000 - Type 8476 135