IBM 86601RU Hardware Maintenance Manual - Page 181
Hot-plug PCI adapter installation, operating system.
![]() |
UPC - 087944414230
View all IBM 86601RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 181 highlights
Hot-plug PCI adapter installation This section gives the procedure for installing a hot-plug PCI adapter. If you want to remove a hot-plug adapter, reverse the steps. If the operating system supports hot-replace PCI adapters, you can replace a failing hot-plug PCI adapter with a new adapter of the same type without turning off power to the server. If the operating system and adapter also support the hot-add feature, you can install a new adapter without turning off the power to the server. Note You do not need to turn the server off to install or remove a hot-plug PCI adapter. Before you begin: Read "Safety information" on page 308. Read the documentation that comes with the adapter for any special requirements or restrictions. Read the documentation that comes with the operating system. Attention Do not remove a hot-plug adapter before performing the operating-system-defined procedure for disabling the hot-plug PCI slot that contains the adapter. Failure to do so might cause the system to lock up. Refer to the operating system documentation. Refer to the following illustrations while you perform the steps in this procedure. Netfinity 5500 - Type 8660 173
![](/manual_guide/products/ibm-866011u-hardware-maintenance-manual-12f5559/181.png)