IBM 86601RU Hardware Maintenance Manual - Page 270
Top cover removal, Before you begin, To remove the server top cover, Attention
UPC - 087944414230
View all IBM 86601RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 270 highlights
Top cover removal Before you begin: Read "Safety information" on page 308. Note You do not have to power-off the system to replace a hot-swap fan. To remove the server top cover: 1. Turn off the server and all attached devices and disconnect all external cables and power cords (see "Preparing to install options" on page 220). 2. Loosen the two thumbscrews 1 on the back edge of the top cover. 3. Slide the top cover 2 slightly toward the rear of the server; the cover will stop after about 25 mm (1 inch). Lift the cover off the server and set the cover aside. Attention For proper cooling and airflow, replace the top cover before turning on the server. Operating the server for extended periods of time (over 30 minutes) with the top cover removed might damage server components. Go to "Server door and trim bezels removal" on page 252. 262 Netfinity Server HMM