IBM 86601RU Hardware Maintenance Manual - Page 383
Center the VRM, correctly; then, press the VRM into
UPC - 087944414230
View all IBM 86601RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 383 highlights
For the core/bus ratio 5.0 (500/100 MHz), jumpers are installed on pins 1 and 2 of J30 and J31 and on pins 2 and 3 of J28 and J29. 7. Install the voltage regulator modules (VRMs) 12 included in the microprocessor kit: a. Determine the connectors where the VRMs are to be installed. See Table 15 on page 372. The microprocessor upgrade kit comes with two VRMs. You might need to install only one, depending on the number of microprocessors in the server. b. Center the VRM 12 over the connector 11 . Make sure that the VRM is oriented and aligned correctly; then, press the VRM into the connector. c. Repeat the preceding step for the second VRM, if needed. Note If you need to install only one VRM, store the remaining VRM in a safe place to use as a replacement. 8. Go to "Installing memory-modules" on page 376. 4-way Xeon upgrade installation 375