IBM 86601RU Hardware Maintenance Manual - Page 248
Installing the server in the rack, the side of the server.
![]() |
UPC - 087944414230
View all IBM 86601RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
Installing the server in the rack: In this section, you will use eight screws (M4 by 8). To install the server in the rack: 1. Fully extend the slide-bracket assemblies until they lock. 2. Install the four lift handles on the sides of the server: a. Press in on the sides of the lift handle near the tabs and insert the handle tabs into the slots on the side of the server. b. Move the handle up in the slots so that the hooked part of each tab is inside the server. Release the pressure on the sides of the handle. c. Install the remaining three lift handles. 240 Netfinity Server HMM
![](/manual_guide/products/ibm-866011u-hardware-maintenance-manual-12f5559/248.png)
Installing the server in the rack:
In this section,
you will use eight screws (M4 by 8).
To install the server in the rack:
1.
Fully extend the slide-bracket assemblies until they
lock.
2.
Install the four lift handles on the sides of the server:
a.
Press in on the sides of the lift handle near the
tabs and insert the handle tabs into the slots on
the side of the server.
b.
Move the handle up in the slots so that the
hooked part of each tab is inside the server.
Release the pressure on the sides of the handle.
c.
Install the remaining three lift handles.
240
Netfinity Server HMM