IBM 867282X Maintenance Manual - Page 34
Error code, Description, Explanation, Action, Start, Control Panel, Networks, Adapters, Properties
UPC - 087944650966
View all IBM 867282X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Table 4. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet controller (continued) Error code (hex) Description 0x03 Explanation: Failed self-test. Action: Make sure a cable is attached to the Ethernet connector. 0x0D Explanation: Could not allocate enough memory for transmit queues. Action: 1. From the Windows NT desktop, select Start → Control Panel → Networks → Adapters. 2. Select your IBM Ethernet adapter from the list. 3. Select Properties → Advanced. 4. Lower the resource values that apply to the transmit queue. 0x0E Explanation: Could not allocate enough memory for receive queue. Action: 1. From the Windows NT desktop, select Start →Control Panel →Networks →Adapters. 2. Select your IBM Ethernet adapter from the list. 3. Select Properties →Advanced. 4. Lower the resource values that apply to the receive queue. 0x0F Explanation: Could not allocate enough memory for other structures. Action: 1. From the Windows NT desktop, select Start → Control Panel → Networks → Adapters. 2. Select your IBM Ethernet adapter from the list. 3. Select Properties →Advanced. 4. Lower the value for the resource named in the message. 0x10 Explanation: Did not find any Ethernet controllers. Action: Using the Configuration/Setup Utility program, make sure that Ethernet is enabled. 0x11 Explanation: Multiple Ethernet controllers found, but none matched the required ID. Action: Using the Configuration/Setup Utility program, make sure that Ethernet is enabled. 0x13 Explanation: Did not find any Ethernet controllers that matched the required subven/subdev. Action: Using the Configuration/Setup Utility program, make sure that Ethernet is enabled. 0x16 Explanation: Single adapter found, but multiple instances tried to load. Action: Using the Configuration/Setup Utility program, make sure that Ethernet is enabled, and that the slot containing the IBM xSeries 200 10/100 Ethernet Adapter or the IBM 10/100 Etherjet PCI adapter is enabled. 0x17 Explanation: Slot parameter not specified in the registry. Action: Remove the adapter driver and reinstall it. 26 Hardware Maintenance Manual: xSeries 300