IBM 8685 Hardware Maintenance Manual - Page 159
Run the Configuration/Setup Utility program and diagnostics.
UPC - 087944957171
View all IBM 8685 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Note: See "System" on page 162 to determine which components should be replaced by a field service technician. Error code/symptom FRU/action 301 (Keyboard or keyboard controller error) Note: After installing a USB keyboard, you might need to use the Configuration/Setup Utility to enable keyboardless operation and prevent the POST error message 301 from being displayed during startup. 1. Keyboard 2. System board 303 (Keyboard controller error) v System board 602 (Invalid diskette boot record) 1. Diskette 2. Diskette drive 3. Cable 4. System board 604 (Diskette drive error) 1. Run the Configuration/Setup Utility program and diagnostics. 2. Diskette drive. 3. Drive cable. 4. System board. 605 (Unlock failure) 1. Diskette drive 2. Drive cable 3. System board 662 (Diskette drive configuration error) 1. Run the Configuration/Setup Utility program and diagnostics. 2. Diskette drive. 3. Drive cable. 4. System board. 762 (Coprocessor configuration error) 1. Run the Configuration/Setup Utility program. 2. Battery. 3. Microprocessor. 962 (Parallel port error) 1. Disconnect the external cable on the parallel port. 2. Run the Configuration/Setup Utility program. 3. System board. 11XX (System board serial port 1 or 2 error) 1. Disconnect the external cable on the serial port. 2. Run the Configuration/Setup Utility program. 3. System board. 1301 (I2C cable to front panel not found) 1. Cable 2. Front panel 3. Power switch assembly 4. System board 1302 (I2C cable from system board to power on and reset switches not found) 1. Cable 2. Power switch assembly 3. System board 1303 (I2C cable from system board to power backplane not found) 1. Cable 2. Power backplane 3. System board Chapter 6. Symptom-to-FRU index 149