IBM 8685 Hardware Maintenance Manual - Page 73
Working with the optional xSeries 6-Pack Hot-Swap Hard Drive Expansion Kit, are known
UPC - 087944957171
View all IBM 8685 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Cable-management arm bracket Cable-management arm Captive screw Tab Fan bay 7 (fan removed) 1) Remove the fan from fan bay 7. 2) Insert the tab on the cable-management-arm bracket into the corresponding slot on the server. 3) Tighten the captive screw on the cable-management-arm bracket to the server. 4) Reinstall the fan in fan bay 7. 17. If you have other options to install or remove, do so now; otherwise, go to "Completing the installation" on page 106. Working with the optional xSeries 6-Pack Hot-Swap Hard Drive Expansion Kit Your server contains hardware that enables you to replace a failed hard disk drive without turning off the server. Therefore, you have the advantage of continuing to operate your system while a hard disk drive is removed or installed. These drives are known as hot-swap drives. The hot-swap drives are attached to a hot-swap hard disk drive backplane. The backplane is a printed circuit board behind the drive bays. For more information about drive bays and drive installation, see "Installing internal drives" on page 73. The low voltage differential (LVD) SCSI hot-swap hard disk drive backplane supports a maximum of six slim-high, hot-swap hard disk drives. Chapter 4. Customer replaceable units 63