IBM 8840 Hardware Maintenance Manual - Page 13
Features, specifications - hyper v
UPC - 000435863799
View all IBM 8840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Features and specifications The following information is a summary of the features and specifications of the server. Depending on the server model, some features might not be available, or some specifications might not apply. Racks are marked in vertical increments of 1.75 inches. Each increment is referred to as a unit, or "U." A 1-U-high device is 1.75 inches tall. Table 1. Features and specifications Microprocessor: Hot-swap power supplies: Acoustical noise emissions: v Intel® Xeon 2.8 GHz or higher v Declared sound power, idle: 6.6 bel depending on server model 625 watts (100-240 V ac) v Declared sound power, operating: 6.6 bel v 800 MHz front-side bus (FSB) v Minimum: One v Support for up to two microprocessors v Maximum: Two - provide redundant Heat output: with Intel Hyper-Threading Technology Note: Use the Configuration/Setup Utility program to determine the type and speed of the microprocessors. Memory: v Minimum: 512 MB power Size (2 U): v Height: 85.4 mm (3.36 in.) v Depth: 698 mm (27.48 in.) v Width: 443.6 mm (17.5 in.) v Weight: approximately 21.09 kg (46.5 lb) to 29.03 kg (64 lb) depending upon Approximate heat output in British thermal units (Btu) per hour: v Minimum configuration: 1230 Btu (360 watts) v Maximum configuration: 2840 Btu (830 watts) v Maximum: 16 GB v Type: 2-way interleaved PC2-3200, ECC DDR II SDRAM, registered DIMMs only v Sizes: 256 MB, 512 MB, 1 GB, or 2 GB. Drives: v Diskette: 1.44 MB v DVD-ROM: IDE Expansion bays: v Six hot-swap, 3.5-inch drive bays (hot-swap hard disk drives installed, some models) v One 5.25-inch bay (DVD-ROM drive configuration Integrated functions: v Baseboard management controller v Two Broadcom 10/100/1000 Ethernet controllers (dual-port design) with Wake on LAN® support v One serial port v One external and one internal Ultra320 SCSI port (dual-channel controller with integrated RAID) v Three Universal Serial Bus (USB) v1.1 ports Electrical input: v Sine-wave input (50-60 Hz) required v Input voltage range automatically selected v Input voltage low range: - Minimum: 90 V ac - Maximum: 137 V ac v Input voltage high range: - Minimum: 180 V ac - Maximum: 265 V ac v Input kilovolt-amperes (kVA) approximately: - Minimum: 0.36 kVA - Maximum: 0.83 kVA installed) Note: The baseboard management v One 3.5-inch removable-media drive bay controller is also known as the service (diskette drive installed) processor. Notes: 1. Power consumption and heat output vary depending on the number and type Expansion slots: v Two PCI-X non-hot-plug 100 MHz/64-bit (low profile) v Two PCI-X non-hot-plug 133 MHz/64-bit Video controller: v ATI Radeon 7000M IGP video on system board v Compatible with SVGA and VGA of optional features installed and the power-management optional features in use. 2. These levels were measured in Hot-swap fans: v Standard: Six v Maximum: 12 - provide redundant cooling v 16 MB DDR-SDRAM video memory Environment: v Air temperature: - Server on: 10° to 35°C (50° to controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 95°F); altitude: 0 to 914.4 m (3000 9296. Actual sound-pressure levels in a ft). Decrease system temperature given location might exceed the average by 0.75°C for every 1000 feet values stated because of room increase in altitude. reflections and other nearby noise - Server off: 10° to 43°C (50° to sources. The declared sound-power 109.4°F); maximum altitude: 2133 m levels indicate an upper limit, below (7000 ft). which a large number of computers will - Shipment: -40° to +60°C (-40° to operate. 140°F) ; maximum altitude: 2133 m (7000 ft). v Humidity: - Server on/off: 8% to 80% - Shipment: 5% to 100% Chapter 1. Introduction 3