IBM 8840 Hardware Maintenance Manual - Page 86
Beep/symptom
UPC - 000435863799
View all IBM 8840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Note: See "System" on page 108 to determine which components a field service technician should replace. Beep/symptom FRU/action 3-3-2 (Critical SMBUS error occurred) 1. Disconnect the server power cord from outlet, wait 30 seconds, and retry. 2. System board. 3. DIMMs. 4. Hard disk drive backplane. 5. Power supply. 6. Power cage assembly. 3-3-3 (No operational memory in system) 1. Install or reseat the memory modules, and then do a 3 boot reset. (For more information on a 3 boot reset, see Chapter 2, "Configuring the server," on page 9). 2. DIMMs. 3. Memory board. 4. System board. 4-4-4 (Optional system management 1. Verify that the adapter is installed in the system management adapter adapter not installed in slot 1 or not slot. functioning correctly) 2. Adapter. 3. System board. Two short beeps (Information only, the configuration has changed) 1. Run Diagnostics. 2. Run the Configuration/Setup Utility program. Three short beeps 1. DIMM 2. System board One continuous beep 1. Microprocessor 2. Optional microprocessor (if installed) 3. System board Repeating short beeps 1. Keyboard 2. System board One long and one short beep 1. Video adapter (if installed) 2. System board One long and two short beeps 1. Video adapter (if installed) 2. System board One long and three short beeps 1. Monitor 2. Video adapter, if installed 3. System board Two long and two short beeps Video adapter 76 xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide