IBM DTLA-305040 Hard Drive Specifications - Page 29
Operating modes
View all IBM DTLA-305040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
4.4.7 Operating modes 4.4.7.1 Operating mode descriptions Operating mode Description Spin-up Start up time period from spindle stop or power down Seek Seek operation mode Write Write operation mode Read Read operation mode Idle Spindle motor and servo system are working normally. Commands can be received and processed immediately. Standby Actuator is unloaded and spindle motor is stopped. Commands can be received immediately. Sleep Actuator is unloaded and spindle motor is stopped. Only soft reset or hard reset can change the mode to standby. Note: Upon power down or spindle stop a head locking mechanism will secure the heads in the OD parking position. 4.4.7.2 Mode transition times Mode transition times are shown below. From Standby To Idle RPM 5400 (2 disks) 7200 (3 disks) 7200 (5 disks) Transition time (typical ) (sec) 8 12 14 Transition time (max) (sec) 31 31 31 Idle Standby Immediately Immediately Standby Sleep Immediately Immediately Sleep Standby Immediately Immediately Note: The command is processed immediately but there will be an actual spin down time reflecting the seconds passed until the spindle motor stops. Figure 15. Mode transition times Deskstar 40GV & 75GXP hard disk drive specifications 17