IBM DTLA-305040 Hard Drive Specifications - Page 82

9.1 Alternate Status Register Alternate Status Register 76 BSY RDY 5 4 3 2 1 0 DF DSC/ SERV DBQ COR IDX ERR Figure 67. Alternate Status Register This register contains the same information as the Status Register. The only difference is that reading this register does not imply interrupt acknowledge or clear a pending interrupt. See 9.13, "Status Register" on page 0 for the definition of the bits in this register. 9.2 Command Register This register contains the command code being sent to the device. Command execution begins immediately after this register is written. The command set is shown in Figure 84 on page 0. All other registers required for the command must be set up before writing the Command Register. 9.3 Cylinder High Register This register contains the high order bits of the starting cylinder address for any disk access. At the end of the command this register is updated to reflect the current cylinder number. In LBA Mode this register contains Bits 16-23. At the end of the command this register is updated to reflect the current LBA Bits 16-23. The cylinder number may range from zero to the number of cylinders minus one. 9.4 Cylinder Low Register This register contains the low order bits of the starting cylinder address for any disk access. At the end of the command this register is updated to reflect the current cylinder number. In LBA Mode this register contains Bits 8-15. At the end of the command this register is updated to reflect the current LBA Bits 8-15. The cylinder number may be from zero to the number of cylinders minus one. Deskstar 40GV & 75GXP hard disk drive specifications 70