Icom IC-7000 Instruction Manual - Page 101
Measuring SWR - power output
View all Icom IC-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
6 FUNCTIONS FOR TRANSMIT ■ Measuring SWR The IC-7000 has a built-in circuit for measuring antenna SWR-no external equipment or special adjustments are necessary. The IC-7000 can measure SWR in 2 ways-spot measurement and plot measurement. The SWR can only be measured on [ANT1] connector, in the HF/50 MHz bands when an antenna is connected. However, when a 144/430 MHz antenna is connected to [ANT2], the SWR cannot be measured. D Spot measurement q Select CW or RTTY operation with [MODE]. w Confirm that the output power is over 30 W. e Select S-1. r Push [F-3 MET] one or more times to select the SWR meter. t Key down or push [PTT] to transmit; then read the actual SWR from the meter. ➠ ≤ 1.5 well matched antenna ➠ > 1.5 check antenna or cable connection, etc. [MENU/GRP] [F-3] SWR 1 1�5 2 - 3 ∞ The best match is in this range. 6 D Plot measurement Plot measurement allows you to measure the SWR over an entire band. q Confirm that the output power is over 30 W. w Set the center frequency for the SWR to be measured. e Select G-3 (SWR meter). r Hold down [F-4 step] for 1 second one or more times to select the desired measuring step from 10, 50, 100 and 500 kHz. t Push [F-2] or [F-3] one or more times to select the desired number of measuring steps from 3, 5, 7, 9, 11, and 13 steps. y Push [F-1] to start the measuring. u Hold down [PTT] on the microphone to measure the SWR. • Frequency marker, "∫," appears below SWR graph. • RTTY mode is automatically selected. i When releasing [PTT], the frequency marker and frequency indication move to the next frequency to be measured. o Repeat steps u and i to measure SWR over the entire frequency range. !0 When the measured SWR is less than 1.5:1, the antenna is well matched with the transceiver in the measured frequency range. Push [F-1] to start mesuring. Push [F-4] to Select SWR mesuring steps. Push [F-2] or [F-3] to select number of SWR mesuring steps. • Measuring (after pushing [F1]) Frequency marker appears and moves after measurement. 4.0 : 1 3.0 : 1 2.0 : 1 1.5 : 1 1.0 : 1 The antenna is well matched in this range 92