Insignia NS-LBD32X-10A User Manual (English) - Page 14

NS-LBD32X-10A Insignia 32" LCD TV/Blu-ray DVD Combo, 1080p Connecting an antenna or cable TV (no box) To connect an antenna or cable TV (no box): • Connect one end of a 75 ohm coaxial cable to the antenna or cable wall jack, then connect the other end of the cable to the ANT. jack on the back of your TV/Blu-ray combo. If your antenna cable has a 300 ohm twin-lead connector, use a 300-75 ohm adapter. Antenna jack 75 ohm coaxial cable Antenna jack 300 ohm twin-lead connector with 300-75 ohm adapter Connecting a cable or satellite TV box Note Installation methods may vary depending on the type of cable or satellite box. Contact your cable or satellite provider for more information. To connect a cable or satellite box: 1 Connect a 75 ohm coaxial cable to the cable or satellite TV wall jack, then connect the other end to the Antenna IN jack on the cable or satellite TV box. Antenna IN RF OUT Cable or satellite TV box Coaxial cable from wall jack ANT. jack Note • Always unplug the coaxial cable when you move your TV/Blu-ray combo. • If you switch between antenna and cable, install an antenna selector. • If you need help connecting cable TV, contact your cable TV provider. To connect a combination VHF/UHF antenna with separate VHF and UHF 300 ohm twin-lead wires: 1 Connect the UHF 300 ohm twin-lead wire to the combiner (not supplied). 2 Connect the VHF 300 ohm twin-lead wire to the 300-75 ohm matching transformer. 3 Attach the transformer to the combiner, then attach the combiner to the ANT. jack on the back of your TV/Blu-ray combo. 2 Connect a 75 ohm coaxial cable to the RF OUT jack on the cable or satellite TV box, then connect the other end to the ANT. jack on the back of your TV/Blu-ray combo. If you subscribe to a cable TV service in which basic channels are unscrambled and premium channels require the use of a converter/descrambler box, you may want to use a signal splitter and an A/B switch box (available from the cable TV company or an electronics supply store). To connect cable TV with a converter/descrambler box: • Use the following illustration to connect a converter/descrambler box. Cable or satellite box Coaxial cable Coaxial cable Splitter A/B switch ANT. jack Set the RF switch to the A position to tune to unscrambled channels using your TV/Blu-ray combo remote control. Set the RF switch to the B position to watch scrambled channels using the converter/descrambler controls. 10 www.insigniaproducts.com