Insignia NS-R5101AHD-A User Manual (English) - Page 18

NS-R5101AHD-A_10-0487_MAN_.book Page 14 Friday, May 7, 2010 7:51 AM Insignia NS-R5101AHD-A AV Home Theater Receiver To install the batteries: 1 Remove the cover. Batteries (AA/R6) 2 Insert two AA batteries into the compartment matching the polarity indicated. 3 Replace the cover. Using the remote control Use the remote control by pointing it towards the receiver's remote sensor window. Objects between the remote control and sensor window may prevent proper operation. Remote control sensor Receiver Approx. 16 ft. (5 m) Use the remote control within about 16 feet (5 meters) of the receiver and within 30 degrees of perpendicular to the front of the receiver. Cautions • Do not expose the remote control to shock. In addition, do not expose the remote control to liquids, and do not place in an area with high humidity. • Do not place the remote control under direct sunlight. The heat may cause deformation of the remote control. • The remote control may not work properly if the remote sensor window of the receiver is under direct sunlight or strong lighting. In such a case, change the angle of the lighting or receiver, or operate the remote control closer to the remote sensor window. Using the Audyssey 2EQ® room correction and speaker setup With the supplied calibration microphone, Audyssey 2EQ® automatically determines the number of speakers connected, their size (for purposes of bass management), optimum crossover frequencies to the subwoofer (if present), and distances from the primary listening position. Audyssey 2EQ then removes the distortion caused by room acoustics by capturing room acoustical problems over the listening area in both the frequency and time domain. The result is clear, well-balanced sound for everyone. Enabling Audyssey 2EQ lets you also use Audyssey Dynamic EQ®, which maintains the proper octave-to-octave balance at any volume level. Before using this function, connect and position all of your speakers. It takes about 15 minutes to complete the room correction and speaker setup for three positions. Total measurement time varies depending on the number of speakers. Using Audyssey 2EQ® To create a listening environment in your home theater that all listeners can enjoy, Audyssey 2EQ® takes measurements at up to three positions within the listening area. Position the microphone at ear height of a seated listener with the microphone tip pointed directly at the ceiling using a tripod. Do not hold the microphone in your hand during measurements as this produces inaccurate results. First measurement position (1)-Also referred to as the Main Listening Position this refers to the most central position where one would normally sit within the listening environment. 2EQ uses the measurements from this position to calculate speaker distance, level, polarity, and the optimum crossover value for the subwoofer. Second measurement position (2)-The right side of the listening area. Third measurement position (3)-The left side of the listening area. The distances from position 1 to 2 and 1 to 3 must be at least 3.3 feet (1 meter). TV 14 www.insigniaproducts.com