Insignia NS-R5101AHD-A User Manual (English) - Page 20
Operating your receiver - review
UPC - 600603128851
View all Insignia NS-R5101AHD-A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
NS-R5101AHD-A_10-0487_MAN_.book Page 16 Friday, May 7, 2010 7:51 AM Insignia NS-R5101AHD-A AV Home Theater Receiver If Subwoofer appears on the Review Speaker Configuration screen as No, increase the subwoofer's volume to the half-way point, set it to its highest crossover frequency, and then try running Audyssey 2EQ® Room Correction and Speaker Setup again. Note that if the volume is set too high and the sound distorts, detection issues may occur, so use an appropriate volume level. If the subwoofer has a low-pass filter switch, set it to Off or Direct. Operating your receiver Turning your receiver on and off To turn your receiver on and off: 1 Press ON/STANDBY on the front panel. - OR - Press RECEIVER, then ON/STANDBY on the remote control. The receiver turns on, the display lights, and the STANDBY indicator turns off. 2 Press ON/STANDBY on the remote control again. The receiver enters standby mode. To prevent any loud surprises when you turn on the receiver, always turn down the volume before you turn it off. Understanding basic operations Notes • • The on-screen setup menus appear only on a TV that is connected to the HDMI OUT jack. If your TV is connected to the MONITOR OUT V or the COMPONENT VIDEO OUT jacks, use the receiver's display when changing settings. This manual describes the procedure using the remote control unless otherwise specified. Playing a connected component To play a connected component: 1 Press RECEIVER, then press INPUT SELECTOR buttons to select the input source. 2 Start playback on the source component. 3 To adjust the volume, use the MASTER VOLUME control. 4 Select a listening mode and enjoy! See also "Using the listening modes" on page 18. Displaying source information To display source information: • Press RECEIVER, then press DISPLAY repeatedly to cycle through the available information. The following information can typically be displayed: Input source and volume Signal format or sampling frequency Input source and listening mode Notes • • • When AM or FM radio is used, the band, preset number, and frequency are displayed. If the input signal is analog, no format information is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format is displayed. Information is displayed for about three seconds, then the previously displayed information reappears. The input source is displayed with the default name even when you have selected a name. See "Naming inputs (Name Edit menu)" on page 24. Using the music optimizer The music optimizer enhances the sound quality of compressed music files. To use the music optimizer: 1 Press AUDIO, then press or to select M.Optimizer. 2 Press or to select On. The M.Opt indicator lights on the display. Notes • • The music optimizer function only works with PCM digital audio input signals with a sampling rate below 48 kHz and analog audio input signals. The music optimizer is disabled when the direct listening mode is selected. The setting is stored individually for each input selector. Setting the display brightness You can adjust the brightness of the receiver's display. To set the display brightness: • Press RECEIVER, then press DIMMER repeatedly to select: Dim, Dimmer, or Normal brightness. Muting the receiver To mute the receiver: • Press RECEIVER, then press MUTING. 16 www.insigniaproducts.com