Intermec PX4i Double Serial Interface Kit Installation Instructions - Page 13
EasyCoder PM4i Printers
View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Chapter 2 - Physical Installation EasyCoder PM4i Printers • Switch off the printer and disconnect the power cord. • Disconnect all communication cables. • Turn the printer over so it rests on its left-hand cover. Use a soft cloth or similar to avoid scratches. • Open the right-hand door. • Using a #T20 Torx screwdriver, remove the four screws that hold the cover along the lower left edge of the bottom plate and the four screws that hold the cover to the center section. • Put the printer back on its feet and remove the cover while disconnecting the console cable from the CPU board. The electronic compartment contains wires and components with dangerous voltage (up to 380V). Make sure that the printer is switched off and the power cord is disconnected before the cover is removed. • Put the cover aside taking care to avoid scratches. Double Serial Interface Kit Installation Instructions 9