Intermec PX4i Double Serial Interface Kit Installation Instructions - Page 17
headlift mechanism.
View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Chapter 2 - Physical Installation • In case of two interface boards, the flat cable should run as illustrated below. $16#PBSE 4QBDFS FYJTUJOH $BCMF *OOFS*OUFSGBDF#PBSE 4QBDFS GSPNLJU 0VUFS*OUFSGBDF#PBSE 4DSFX FYJTUJOH • Put back the cover over the electronics compartment. • Connect the console cable to J50 on the CPU board and put back the cover over the electronics compartment. Take care so the console cable runs above the ribbon motor and does not become entangled in the headlift mechanism. • Connect the power cord and switch on the power. • Enter the Setup Mode to set the proper communication parameters for new the serial communication ports. Double Serial Interface Kit Installation Instructions 13
Double Serial Interface Kit Installation Instructions
13
Chapter 2 — Physical Installation
•
In case of two interface boards, the flat cable should run as illustrated
below.
•
Put back the cover over the electronics compartment.
•
Connect the console cable to J50 on the CPU board and put back the
cover over the electronics compartment. Take care so the console cable
runs above the ribbon motor and does not become entangled in the
headlift mechanism.
•
Connect the power cord and switch on the power.
•
Enter the Setup Mode to set the proper communication parameters
for new the serial communication ports.