Intermec PX4i Double Serial Interface Kit Installation Instructions - Page 22
Always start by fitting an interface board in the left-hand slot.
View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Chapter 2 - Physical Installation • Connect the power cord and switch on the power. • In case the interface board provides additional serial communication ports, enter the Setup Mode to set the proper communication parameters for these ports. Allowed interface combinations (Fingerprint v8.30 or later) Left-hand slot Double Serial Double Serial Double Serial Double Serial Ports uart2: + uart3: uart2: + uart3: uart2: + uart3: uart2: + uart3: Right-hand slot - Double Serial Serial/Industrial IEEE 1284 Ports - uart4: + uart5: uart4: centronics: Serial/Industrial Serial/Industrial Serial/Industrial Serial/Industrial uart2: uart2: uart2: uart2: - Serial/Industrial Double Serial IEEE 1284 - uart3: uart3: + uart4: centronics: IEEE 1284 centronics: - - IEEE 1284 centronics: Double Serial uart2: + uart3: IEEE 1284 centronics: Serial/Industrial uart2: Remarks: • The left-hand slot is the slot closest to the center section. • Always start by fitting an interface board in the left-hand slot. • RS-485 is only supported by "uart2:" "uart3:" "uart5:" "uart2:" "uart4:" 18 Double Serial Interface Kit Installation Instructions