JVC DT100U Instruction Manual - Page 49

Digital Timer Programming This VCR allows you to set recording timer or viewing timer of a digital program. You can also make use of the Electronic Program Guide (EPG) on page 51 to set easy record or easy view timer. • Turn on the VCR and the TV, and select the AV mode on the TV. • Set the [VCR/TV/CABLE/DBS] selector on the Remote to [VCR]. VCR CABLE TV /DBS [DTV MENU] [MENU] [JKHI] [OK] ATTENTION: When performing timer programming of a digital (ATSC) program, the VCR must be set to the standby mode condition 10 minutes before the start time of a program. As timer recording is performed based on the time information of each program, timer standby and timer recording may not be possible due to deviation in the timer information of each program if the VCR is set to standby mode within 10 minutes of the program start time. In such cases, press [REC] to perform manual recording. EN 49 Recording timer A Load a cassette Make sure the record safety tab is intact. B Access Digital Set Up screen Press [DTV MENU]. C Access Digital Program screen A Press [D E] to move DIGITAL SET UP the arrow to "DIGI- DIGITAL PROGRAM TUNER CLOSED CAPTION PARENTAL TAL PROGRAM", DIGITAL PROGRAM then press [G] or [OK]. B Press [OK] at "DIGI- MENU TAL PROGRAM" to EXIT OK SELECT WITH ARROW KEYS SELECT THEN PRESS [OK] access the timer screen. • The clock must be set to access the timer screen. If you have not set the clock, an error message will be displayed. Refer to page 15 for the clock setting procedure. • When the received channel is not a digital (DTV) channel, "CAN NOT SET ON THIS CHANNEL SELECT DTV CHANNEL THEN RETRY" appears on the screen. • When receiving digital broadcast, if the "DIGITAL PROGRAM" is set to access the timer screen at the same instant a blocked program or scene is received, the timer screen will not be displayed. In addition, if a blocked program or scene is received while the timer screen is being displayed, the timer screen will disappear from the screen. D Access Timer Mode screen Press [D E] to move the arrow to "Timer", then press [G] to move the arrow to "Timer mode". E Set record timer A Press [D E] to select "Rec", then press [G] or [OK]. Timer TIMER Timer List Timer mode Controller Rec Program 2 Channel Date Start Time End Time Weekly/Daily Stop Mode Select OK Operate DTV 8-1 May 1 (Wed) 2:30 PM 3:30 PM Once Manual Set Timer BACK Back DTV MENU Exit B Press [FG] to select the individual items "Chan- nel", "Date", "Start Time", "End Time", "Weekly/ Daily" and "Stop mode", and [D E] to enter the desired setting (channel, date, start time etc.). • The "Weekly/Daily" item allows you to choose from a selection of "Once", "Weekly", "Mon-Fri" or "Daily". • You can select between "Manual" and "Event" for the "Stop Mode" item. C Press [FG] to move the arrow to "Set Timer" upon completing the necessary settings, then press [OK]. • An mark appears in front of the program title.