JVC DT100U Instruction Manual - Page 82
S-VIDEO/VIDEO Connections
UPC - 046838015267
View all JVC DT100U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
82 EN S-VIDEO/VIDEO Connections Various connection for editing tapes The following three methods can be used for editing tapes. • VHS to S-VHS editing (VIDEO-VIDEO connection): Although the picture quality is inherently limited by the original VHS quality, the edited tape has better picture quality than those made by VHS-to-VHS editing. • S-VHS to VHS editing (VIDEO-VIDEO connection): Since the original source is recorded in S-VHS mode, the edited tape has better picture quality than those made by VHS-to-VHS editing. • S-VHS to S-VHS editing (S-VIDEO connection): Original picture quality of S-VHS made can be duplicated with minimal picture degradation. This is the best editing method you can use on S-VHS VCRs. A You can use a camcorder as the playback device and your VCR as the recording VCR. This VCR (for recording) EDITING (cont.) B You can use your VCR as the playback or recording VCR. E.g. When using this VCR as the recording VCR i.LINK IN/OUT DV IN HDMI OUT OPTICAL S400 D-THEATER REGION 1 PCM/STREAM DIGITAL AUDIO OUT This VCR (for recording) Y PB/CB PR/CR COMPONENT VIDEO OUT S-VIDEO S-VIDEO ATSC IN VIDEO VIDEO L AUDIO R OUTPUT L AUDIO R L-1 L-2 INPUT CABLE BOX REMOTE PAUSE/ AV COMPULINK VHF/UHF ANTENNA IN OUT ANTENNA To [AUDIO INPUT] Audio cable (supplied) To [S-VIDEO INPUT] S-video cable (supplied) To AUDIO output To S VIDEO output IN F-1 To [AUDIO] input To rear panel [REMOTE PAUSE/AV COMPULINK] To [S-VIDEO] input Audio cable (supplied) S-video cable (supplied) Mini-plug cable (not supplied) (JVC camcorder only) To S-video output To Audio output To EDIT DV camcorder (for playback) Another VCR (for playback) NOTE: When using this VCR as the playback VCR, During playback, if the images cannot be displayed on the TV, press [HDMI] on the front panel to turn off the [HDMI] LED and set "TV OUTPUT 2" to "ALLto480i" (A page 67). In event when even the main menu screen cannot be displayed on the TV when [MENU] is pressed, power off this VCR, press and hold [PAUSE (W)] for more than 5 seconds, then power on the VCR again. A Make connections A Connection with the camcorder Connect an audio/S-video cable between the camcorder's audio/S-video output connectors and your VCR's [AUDIO/S VIDEO] input connectors. • When the JVC camcorder is equipped with the Master Edit Control, you can control the VCR from the camcorder. Connect the miniplug cable (not supplied with this VCR) as illustrated on the left. • When using a camcorder with a monaural output, connect the audio output connector on the camcorder to the [AUDIO L] input connector on this VCR. NOTE: If the camcorder does not have S-video output connector, use a video cable.