JVC DT100U Instruction Manual - Page 66

66 EN Audio settings "AUDIO FUNCTION" OTHER USEFUL FUNCTIONS (cont.) *The default setting is bold in the table below. L "STD AUDIO REC MODE" "STANDARD" "PCM&STANDARD" You can select the audio format when you record a program or analog signal from connected devices in STD mode. When this function is set to "PCM&STANDARD", you can obtain high-quality audio sound. "STANDARD" : Select this when the picture quality is important and when you record in MP2 format. "PCM&STANDARD" : Select this when the sound quality is important. When you record the analog signals or DV signals from the camcorder in STD mode, PCM audio is also recorded in addition to MP2 audio. In HS mode, PCM audio is automatically recorded. L "DV AUDIO REC" "AUDIO1" "AUDIO2" "1+2MIX" Up to four audio signal channels can be input from a DV camcorder through the DV IN connector (i.LINK). This VCR allows you to select and record two of these channels. This setting is used to specify which two channels to record. When there are four DV audio channels (32 kHz): "AUDIO1" : Records the two channels (L/R) of DV AUDIO 1. "AUDIO2" : Records the two channels (L/R) of DV AUDIO 2. "1+2MIX" : Mixes and records both DV AUDIO 1 and 2. When there are two DV audio channels (48 kHz): Because there are only two channels, those two channels are recorded regardless of the DV sound setting. L "OPTICAL OUT" "Dolby D" "2CH-PCM" "STREAM" This VCR can send the Dolby Digital bitstream or PCM Audio to external devices. When you play back a tape including the Dolby Digital bitstream, and if you have a device equipped with Dolby Digital decoder, set this function to "Dolby D". If not, set this function to "2CH-PCM". "STREAM" will be used when you play back a tape including the DTS bitstream, and if you have a device with built-in DTS, or when playing back and receiving audio signals in other new formats. i.LINK IN/OUT DV IN HDMI OUT OPTICAL S400 D-THEATER REGION 1 PCM/STREAM DIGITAL AUDIO OUT To [OPTICAL] This VCR Y PB/CB PR/CR COMPONENT VIDEO OUT S-VIDEO S-VIDEO ATSC IN VIDEO VIDEO L AUDIO R OUTPUT L AUDIO R L-1 L-2 INPUT CABLE BOX REMOTE PAUSE/ AV COMPULINK VHF/UHF ANTENNA IN OUT ANTENNA To DIGITAL AUDIO L "2ND AUDIO REC" "ON" "OFF" Amplifier equipped with Dolby Digital decoder or built-in DTS Note for connection: Remove the protection cap from the cable. Optical cable (not supplied) When this function is set to "ON"; • If a SAP program is received, the SAP audio is recorded on both the normal and Hi-Fi tracks. The main audio is not recorded. • If a non-SAP program is received, the main audio is recorded on both the Hi-Fi and normal tracks. When this function is set to "OFF", the SAP audio cannot be recorded.