JVC GY-DV500E Instruction Manual - Page 33
Outputting S.S.F. Data, Writing S.S.F. Data to Tape, Connecting a Video Component with DV
View all JVC GY-DV500E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
10. S.S.F. (Super Scene Finder) FUNCTION 10-5 Writing S.S.F. Data to Tape LOG REW STOP FF PLAY STILL 1. STOP button 2. LOG button 2. REW button FILTER 1 3200k 2 5600k 3 5600k+ND SHUTTER STATUS MENU ALARM MONITOR AUTO IRIS FULL AUTO BLACK BACK L NORMAL SPOT L STRETCH NORMAL COMPRESS LOLUX PRST A B ON KNEE OFF AUTO BARS CAM HML SAVE STBY VTR GAIN OUTPUT WHT.BAL NG POWER ON OFF OPERATE/WARNING RESET MONITOR SELECT CH-1 AUDIO CH-2 LEVEL LIGHT ON OFF COUNTER CTL TC UB CH-1 AUDIO LEVEL CH-2 LITHIUM BATT. CH-1 CH-2 TC GENERATOR AUTO MANUAL PRESET REGEN AUDIO SELECT FREE REC AUDIO INPUT CH-1 CH-2 CONTINUE MENU FRONT REAR GROUP HOLD ITEM SELECT DATA SET SHIFT ADVANCE PRESET CONTINUE button S.S.F. data stored in the unitís memory can be written to the beginning of tape. Operation 1. Press the STOP button to enter the stop mode. 2. Press the REW button while the LOG button is kept pressed. • The REW indicator blinks during tape transport in the writing position. • The LOG indicator lights while S.S.F. data are being written to the tape. • When writing to the tape is completed, the LOG indicator goes out. About the Scene End Cue Up Function When the CONTINUE button is pressed while the LOG button is kept pressed in the stop mode, the tape winds to the S.S.F. data's last OUT point, after which the unit enters the record-pause mode. (Scene End Cue Up) The FF button's LED blinks during the Scene End Cue Up mode. Note: Once a tape with recorded S.S.F. data is ejected and then reinserted again, the previous data will be erased if new S.S.F. data are recorded on the tape. 10-6 Outputting S.S.F. Data PUSH The S.S.F. data stored in the unit's memory can be output by RS-232C control via the VTR REMOTE connector. DV CAMCORDER GY-DV500 Y/C OUT MONITOR OUT LINE OUT CH-1 CH-2 VTR REMOTE SYNC IN TEST OUT MIC IN LENS VTR REMOTE connector 63 11. USING EXTERNAL COMPONENTS 11-1 Connecting a Video Component with DV Connector Rear section of GY-DV500 EARPHONE DV CH-1 AUDIO IN CH-2 LINE MIC LINE MIC DC INPUT +48V ON +48V ON TALLY DC OUTPUT DV connector Video component with DV Connector DV connector DV cable Connection Connect the DV connector on the GY-DV500 to the DV connector on the video component using the DV cable. Settings Recording the image of the video component with DV connector on the GY-DV500 • To input the image via the DV connector, set the VCR Setup Menu item No. 126 INPUT SELECT to "IEEE1394". * Settings cannot be changed during recording. See page 68. ↑ U-ver. only Recording the playback image or audio of the GY-DV500 on the video component with DV connector • To remote control the playback operation of the GY-DV500 from the video component with DV connector, set the VCR Setup Menu item No. 050 REMOTE SELECT to "IEEE1394". See page 68. 64