JVC GY-HM170U Instruction Manual - Page 67
Monitoring Audio Sound During Recording Using a Headphone, Setting the Audio recording Level in
View all JVC GY-HM170U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Shooting Memo : 0 When [Main Menu] B [A/V Set] B [Audio Set] B [Limiter] is set to "Off" while in the automatic adjustment mode, the limiter operates at -6 dBFS. 0 When [A/V Set] B [Audio Set] B [Audio On FULL AUTO] is set to "SW Set", you can switch the audio recording mode with the [CH1/CH2 AUTO/MANUAL] selection switch on the camera recorder even if the [FULL AUTO] button is set to "ON". (A P112 [ Audio On FULL AUTO ] ) Monitoring Audio Sound During Recording Using a Headphone You can check the recorded audio using headphone. Setting the Audio recording Level in the Main Menu * Enabled only when the handle unit is not attached. 1 Select [Main Menu] B [A/V Set] B [Audio Set] B [Audio Level]. 0 The [Audio Level] screen appears. Audio Level Auto Manual Set . * The contents displayed on the screen vary depending on the various settings. 2 Select "Auto" or "Manual" using the [LOLUX/3] button. 0 If "Auto" is selected, the audio recording level will be automatically adjusted. 0 If "Manual" is selected, the volume appears on the screen. Use the cross-shaped button (H I) to adjust the volume. Memo : 0 When the [FULL AUTO] button is set to "On" and [Audio On FULL AUTO] in the menu is set to "Auto", the audio recording level cannot be selected. 0 If both CH1 and CH2 are set to the built-in microphone or to AUX, settings for CH2 will not be displayed, and the settings for CH1 will apply to CH2. . 1 Connect the headphone. 2 Select [Main Menu] B [A/V Set] B [Audio Set] B [Monitor]. 3 Adjust the monitor volume using the J / K volume buttons on the side of the camera recorder. Memo : 0 There is no audio output from the monitor speaker in Camera mode. 0 Warning tone is output when there is an abnormality in the camera recorder or when the battery is low. (A P174 [Warning Tone] ) 0 You can set the volume of the warning tone in [Main Menu] B [A/V Set] B [Audio Set] B [Alarm Level]. ("Off"/"Low"/"High") (A P112 [ Alarm Level ] ) Audio Recording 67