Kenwood C-V751 User Manual - Page 61

In case of difficulty What appears to be a mulfunction may not always be serious. If your unit should not perform as expected, consult the table below to see if the problem can corrected before seeking help from your dealer or service representative. 61 How to reset the microcomputer The microcomputer may malfunction (impossibility of operation, erroneous display, etc.) when the power cord is unplugged and plugged in again while the unit is in ON mode with the key pressed or due to other external causes. In this case, execute the procedure on the right to reset the microcomputer and return the unit to the normal condition. 1 Unplug the power cord from the wall outlet. 2 While holding the (ON/STANDBY) key depressed, plug the power cord into the wall outlet again. ÷ Resetting the microcomputer clears the memory you entered and returns it to the initial condition when the unit left the factory. Amplifier Symptom Cause Remedy Sound is not output or the volume level is low. ÷ Connection cords are unplugged from the jacks. ÷ MUTE is ON. (The MUTE ON indicator is blinking) ÷ The TAPE 2/MONITOR is set to ON. ÷ The selected surround mode does not match the input signal. ÷ Connect them properly referring to "System connection". 58 ÷ Press the MUTE key to OFF. • ÷ Set the TAPE 2/MONITOR to OFF. ÷ Select the surround mode according to the input signal. E Standby LED blinks and sound is not output. ÷ Speaker cords are short-circuited. ÷ Unplug the AC cord, remove the short-circuiting and plug the AC cord again. Sound is not output from the surround speaker and/or center speaker, or their sound is very small. System control is not available when MD or TAPE 1 is selected. ÷ The surround speaker cords and/or center speaker cord are disconnected. ÷ The Surround play mode has not been engaged. ÷ The surround and center speaker levels are set to the minimum positions. ÷ "MD" or "TAPE 1" is not displayed. ÷ Connect them by referring to the power amplifier's instruction manual. ÷ Set the presence mode. i ÷ Adjust the surround and center speaker lev- els. ÷ Set up the GRC unit properly. % System control is not available when DVD ÷ "DVD" or "DVD 6ch INPUT" is not displayed. ÷ Switch the display to show "DVD" or "DVD or 6ch INPUT is selected. 6ch INPUT". 0% System control is impossible. ÷ System control cords are connected incorrectly. ÷ Connect them correctly by referring to "Sys- tem connection". 58 Tuner Symptom Radio stations cannot be received. Cause ÷ No antenna is connected. ÷ The broadcast band is not set properly. ÷ The frequency of the desired station is not tuned. Remedy ÷ Connect an antenna. 9 ÷ Set the broadcast band properly. ° ÷ Tune the frequency of the desired station. ° Interference. ÷ Noise due to ignition noise of an automobile. ÷ Noise due to an influence from an electric appliance. ÷ Noise due to a nearby TV set. ÷ Install the outdoor antenna away from the road. ÷ Turn off the power to the appliance. ÷ Install the system farther away from the TV set. A station which was preset cannot be received by pressing the corresponding numeric key. ÷ The preset memory was cleared because the power cord had been unplugged for a long period of time. ÷ The TUNER input is not selected. ÷ Preset the stations by auto memory again. , ÷ Select the TUNER input.