Kenwood TS-2000 Operation Manual - Page 120
Built-in Tnc Command List, Kenwood
![]() |
View all Kenwood TS-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
21 APPENDIX BUILT-IN TNC COMMAND LIST All descriptions in this section are for the users convenience only. KENWOOD will not support or warrantee this documentation in any way. The built-in TNC does not support the digipeater functions due to the RAM capacity. Command Name AUTOLF Short AU Default Parameter Description ON ON/ OFF When ON, sends a line feed (LF) to the computer after each carriage return (CR). AWLEN AW 8 7/ 8 Sets the length of bits between TNC and its host. BEACON BTEXT EVERY/ If set to EVERY, sends a beacon packet at intervals of the B EVERY 0 AFTER n specified period (n). If set to AFTER, sends a beacon (n = 0 ~ packet only once after the specified period (n). The unit of 250) n is 10 seconds. BT - 0 ~ 159 Specifies the content of the data portion of a beacon characters packet. CALIBRA CAL - - Sends a space/mark square wave (50/50 ratio). Enter Q to exit Calibrate mode and restore the Command mode. CHECK CH 30 0 ~ 250 Specifies the interval from signal drop-out until execution of disconnection. The unit of the parameter is 10 seconds. CONNECT C Call1 (VIA Sends a connect request. Call1 is the call sign of the - call2, call3, station to be connected to. Call2 to call9 are call signs of ... call9) stations to be digipeated through. CONVERSE CONV or K - - Causes the TNC to enter Converse mode. Press [Ctrl]+[C] to restore the Command mode. CPACTIME CP OFF ON/ OFF When ON and in Converse mode, sends a packet at intervals of the period determined by PACTIME. CR CR ON ON/ OFF When ON, appends a carriage return (CR) to all packets to be sent. DISCONNE D DISPLAY DISP DWAIT DW ECHO E FIRMRNR FIR - - 30 ON OFF - Sends a disconnect request. - 0 ~ 250 Causes the TNC to display the current status of all the commands. You can also specify a class identifier A, C, H, I, L, M, or T to display the status of only the desired command class. Enter a space between the command name and a class identifier; ex. DISPLAY H. A (ASYNC): RS-232C port parameters C (CHAR): Special TNC characters H (HEALTH): Counter parameters I (ID): ID parameters L (LINK): TNC-to-TNC link status M (MONITOR): Monitor parameters T (TIMING): Timing parameters Specifies the interval from no carrier detection until execution of transmission. The unit of the parameter is 10 milliseconds. ON/ OFF When ON, causes the TNC to echo received characters to the computer. ON/ OFF The other station sends a notice (packet) to you if it is not ready to receive data. When ON, receiving such a notice causes the TNC to suspend transmission until it receives a "ready" notice. 110
![](/manual_guide/products/kenwood-ts2000-operation-manual-ab192f5/120.png)