Kenwood TS-2000 Operation Manual - Page 22

4 GETTING ACQUAINTED 54 PF F LOCK A ATT LEVEL VOX PRE LEVEL PROC SEND ANT1/2 AT PHONES LEVEL LEVEL MIC MANUAL N.R. LO/ WIDTH B.C. A.N. 1 2 3 CH1/REC CH2/REC CH3/REC 4 5 6 TONE/SEL METER CTCSS/SEL 7 8 9 NB/LEVEL AGC/OFF FINE/STEP . 0 DCS/SEL SHIFT/OFFSET ENT HI/ SHIFT FUNC MAIN CAR MIC TX MONI PWR DELAY KEY AUTO LSB USB REV CW FSK NAR FM AM CLR DISP SEL 1MHz 55 45 46 44 47 HF/VHF/UHF ALL MODE MULTI BANDER TS-2000 CW TUNE RIT ALT XIT 9.6k STA CON RIT/SUB SUB MENU TFSET _ CLEAR P.C.T SET QUICK MEMO MANUAL BC MAIN RF GAIN MR M.IN + MULTI CH C.IN CALL MAIN SUB CTRL SG.SEL SCAN SATL M/S REV A/B SPLIT VFO/CH TRACE VFO/M A=B MG.SEL M VFO M.IN MAIN AF SUB SQL 52 53 48 49 50 51 $4 RIT/SUB control After switching the RIT or XIT function ON, turn this control to select the desired frequency offset {pages 38, 40}. Turn to adjust the sub-receiver frequency when the RIT and XIT functions are switched OFF and the subreceiver is switched ON {page 45}. $5 MANUAL BC control Turn to adjust the audio notch frequency while the DSP beat cancel function is set to the manual frequency adjustment mode {page 56}. $6 MAIN RF GAIN control Turn to adjust the radio frequency gain for the main transceiver {page 18}. $7 MULTI/ CH control In VFO mode, rotate to step the operating frequency up or down {page 37}. In memory channel mode, rotate to select a memory channel {page 58}. Also used for selecting Menu numbers when accessing the Menu mode {page 21} and as a selector to choose settings for various functions activated by front panel buttons. The MULTI/ CH LED lights when the setting(s) can be changed using the MULTI/ CH control. $8 MAIN SQL control Used for muting ("squelching") the speaker, the head phones and AF output on ACC2 (13-pin DIN connector) when no receive signal is present on the main transceiver {page 19}. $9 MAIN AF control Turn to adjust the volume on the main transceiver {page 19}. %0 SUB SQL control Used for muting ("squelching") the speaker, head phone and AF output on ACC2 (13-pin DIN connector) when no receive signal is present on the sub-receiver {page 46}. %1 SUB AF control Press to switch the sub-receiver ON or OFF. When it is ON, the SUB-receiver LED lights orange. Turn to adjust the volume for the sub-receiver. %2 LO/ WIDTH control Turn clockwise/ counterclockwise to increase/ decrease the value for the low cut-off DSP filter frequency or the filter bandwidth (CW/ FSK). The selected value appears on the main dot-matrix display {page 55}. %3 HI/ SHIFT control Turn clockwise/ counterclockwise to increase/ decrease the value for the high cut-off DSP filter frequency or the Shift frequency. The selected value appears on the sub dot-matrix display {page 55}. %4 MAIN band LED Lights green while the main transceiver's squelch is open. Lights red while transmitting on the main transceiver's VFO band. %5 SUB band LED Lights green while the sub-receiver's squelch is open. Lights red while transmitting on the sub-receiver's VFO band. 12