Kenwood TS-2000 Operation Manual - Page 24
Display, Meter, Multi/ Ch
![]() |
View all Kenwood TS-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
4 GETTING ACQUAINTED DISPLAY 8 12 14 16 1 6 7 11 13 15 S1 PWR ALC 35 10 79 20 25 50 FILTER 40 60dB 100W% 23 4 5 10 9 q METER While receiving, serves as an S-meter to measure and display the received signal strength. It also displays the filter width. While transmitting, serves as a power meter plus an ALC meter, an SWR meter, or a Speech Processor compression meter. The Peak Hold function holds each reading for approximately half a second. Note: SWR meter works only for the HF and 50 MHz bands. w Appears while the internal antenna tuner {page 72} or an external antenna tuner is in-line for the HF/ 50 MHz band reception. e AT Appears while the internal antenna tuner {page 72} or an external antenna tuner is in-line for the HF/ 50 MHz band transmission. r Appears while HF RX ANT {page 76} connector is enabled to receive HF band signals. You cannot transmit the signals though this connector. t Either " " or " " appears, depending on whether the Antenna 1 connector or the Antenna 2 connector is selected for the HF/ 50 MHz band {page 72}. y MHz Appears when the MHz Up/ Down mode using the MULTI/ CH control is switched ON {page 37}. u ALT Appears when ALT (Auto Lock Tuning) is activated for the 1.2 GHz (FM) band {page 72}. i Appears while Memory Recall or Memory Scroll is being used {page 59}. 14 o Shows the memory channel number for the main transceiver. If you select a channel over 99, a leading digit (1 or 2) appears (the memory number ranges from 00 to 299). It also shows the Quick Memory number location (the Quick Memory number ranges from "0_" to "9_"). !0 AUTO Appears when Auto mode selection is activated {page 73}. !1 Appears when the main transceiver is selected for the transmission band. !2 Appears when the main transceiver's functions can be controlled using the front panel keys. !3 ATT Appears when the main transceiver's receiver attenuator (approx. 12 dB) is ON {pages 57, 73}. !4 TNC Appears when the internal TNC is assigned to the main transceiver {page 49}. !5 PRE Appears when the receiver pre-amplifier of the main transceiver is ON {page 57}. !6 + = "+" or "-" appears, indicating which offset direction is selected for the main transceiver. "=" appears when the -7.6 MHz (430 MHz) or -6.0 MHz (1.2 GHz) offset is selected (all E-types only) {page 32}.
![](/manual_guide/products/kenwood-ts2000-operation-manual-ab192f5/24.png)