Kenwood TS-2000 Operation Manual - Page 123
Com Connector, Appendix, Hardware Description, Control Operation
View all Kenwood TS-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
COM CONNECTOR All descriptions in the PC CONTROL COMMAND TABLE are for the users convenience only. KENWOOD will not support or warrantee this documentation in any way. HARDWARE DESCRIPTION This transceiver uses a full-duplex, asynchronous, serial interface for communicating through the male 9-PIN RS-232C COM connector. Each data is constructed with 1 start bit, 8 data bits, and 1 stop bit (4800 bps must be configured as 2 stop bits). No parity is used. The pinout and the pin functions of the COM connector are shown below: COM 9876 54321 Rear panel view COM COM Pin Name Pin No. (Ref.: Computer) 1 NC 2 RXD 3 TXD 4 NC 5 GND 6 NC 7 RTS 8 CTS 9 NC Function (Ref.: Transceiver) - Transmit data Receive data - Signal ground - Receive enable Transmit enable - I/O - Output Input - - Input Output - 21 APPENDIX CONTROL OPERATION Most computers handle data in the form of "bits" and "bytes". A bit is the smallest piece of information that a computer can handle. A byte is composed of eight bits. This is the most convenient form for most computer data. This data may be sent in the form of either serial or parallel data strings. The parallel method is faster but more complicated, while the serial method is slower and requires less complicated equipment. The serial form is, therefore, a less expensive alternative. Serial data transmission uses time-division methods over a single line. Using a single line also offers the advantage of reducing the number of errors due to line noise. Only 3 lines are required theoretically for control of the transceiver via the computer: • Transmit data • Receive data • Ground From a practical standpoint, it is also necessary to incorporate some means of controlling when this data transfer will occur. The computer and transceiver cannot be allowed to send data at the same time! The required control is achieved by using the RTS and CTS lines. For example, the transceiver is placed into the transmit mode whenever the character string "TX;" is sent from the computer. The character string "TX;" is called a computer control command. It tells the transceiver what to do. There are numerous commands available for control of the transceiver. These commands may be incorporated into a computer program written in any high level language. Programming methods vary from computer to computer; therefore, refer to the instruction manuals provided with the terminal program and computer. RXD: Transmit data is serial data transferred from the transceiver to the computer. TXD: Receive data is serial data transferred from the computer to the transceiver. GND: Signal ground pin RTS: This signal is applied to the transceiver. It is used to inhibit transmit data from the transceiver when the computer is not ready to receive data. Transmit data is inhibited when the level is low. CTS: This signal is applied from the transceiver. It is used to inhibit transmit data from the computer when the transceiver is not ready to receive data. Transmit data is stopped when the level is low. 113